A screw is then screwed onto the other end of the plastic pipe as a blocker to block the blade from sliding out of the holder-piece (BLACK). I have to use a small plastic pipe to join the antenna head to the holder-piece (black) with some trimming. The original red "blade" is removed from the holder-piece (black) and a common extendable antenna is used instead.
#Kamen rider ooo henshin fever mod#
So I decided to mod the blade for a more show accurate version, at least in the length. To make it worse, the Jacorder has a super-duper short blade that makes it ridiculous and hilarious. Unfortunately, the belt does not have anywhere to hold these 2 items, nor a container for storing. The DX Kamen Rider Saga (Sagarc) Belt comes with a Wake-Up Fuestle and a weapon called Jacorder. All parts are connected with cable ties and wrapped up with silver-chromed tape. Attached 2 white snap-assembly clips to mimic the original belt where both sides can be detached. Barely adjustable along the belt, very tight. Inside view of the O Scanner holder attaching to the belt. Inside view of holster, adjustable along the belt. Later use a part of this connector for making the sword holster part. Initially wanted to use the fabric strap's snap connector but this belt is too thick. Retained the original belt buckle for length adjustment. Just a picture to show the other side's view. Front of the set shown in below picture.Īdded a simple strap-holster for the sword using velcro-straps and a part of a snap-assembly connector. was pleasantly happy for most of the belts and snap buckles received, but the narrower belts (to be used for the candy toy belts) are a little too thick and can't be sewn with my normal-sized needle easily.Īnyway, manage to spend the whole evening, night, early morning for making a new belt for my little nephew's candy toy KR OOO belt and weapon set. Yesterday collected the belts ordered from Taobao.
0 kommentar(er)
